The Diesel Stop banner

Question for you transmission builders

1041 Views 4 Replies 4 Participants Last post by  BlindViper
I have my E4OD disassembled. I made the tools needed for compressing the first piston spring and slide hammers for the pump. My question is do I really need the pump banding clamp and the other tools? Is it possible to just line up the holes and torque the bolts down? I mean it can only go on one way right?

1 - 1 of 5 Posts
I didn't use a banding tool or hose clamps. I used a 6 inch straight edge and went around the outer surface tapping the cover back and forth till it was perfect.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.