The Diesel Stop banner

Rear spring front bushings Question

1001 Views 4 Replies 3 Participants Last post by  Garbage_Mechanic
Hey Gals/Guys,

Want to change out the stock front spring hanger (eye on end of spring) rubber bushings on rear springs. Have velvets on the back end and was thinking I could just jack up (after removal of front eye bolt) until spring eye was below hanger. Pound out old rubber bushing and replace with what....? Stock Rubber or aftermarket poly any suggestions, part numbers etc would be great....anything I should be aware of before going at it??


1 - 1 of 5 Posts
just re&re the whole spring and use poly, Lordco has sets of them
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.