The Diesel Stop banner
Cancel

Remove exhaust manifold to remove head?

1720 Views 6 Replies 3 Participants Last post by  xtremefreerider, 
R
My ford factory manual says to remove right exhaust manifold to pull the heads.
Is this necessary or can i just yank the heads out with a cherry picker with the exhaust manifolds attached?

Thanks-----Robert
Reply
Save
Like
1 - 2 of 7 Posts
cdnsarguy
I believe if your doing the head removal with engine in the truck removal of the pax E manifold would make it easier. You will have to play with the push rods at the back, using a rubber band hold the one(s) you cannot remove suspended in place when you remove the head.
Reply
Save
Like
cdnsarguy
I was going to suggest that too, go for it since you know how.
Reply
Save
Like
1 - 2 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
The Diesel Stop
A forum community dedicated to all Ford Diesel owners and enthusiasts. Come join the discussion about PowerStrokes, performance, modifications, troubleshooting, towing capacity, maintenance, and more!
Full Forum Listing
Explore Our Forums
99 & up 7.3L Power Stroke Engine & Drivetrain 6.0L Power Stroke Engine and Drivetrain 99 & up Upgrades and Aftermarket - 7.3L Engine Power Strokes 1994-1997 General 7.3L IDI Diesels (Not Powerstrokes) 1988-1993
Top