The Diesel Stop banner
Cancel

Road Armor bumper reinforcement brackets

1482 Views 1 Reply 2 Participants Last post by  coldair, 
M
I purchased two road armor bumpers, both stealth with titan II. They are for the '01 and '04 Excursion. When I went to install the reinforcement brackets, I couldn't because the front leaf springs attach right where the bracket would slide up behind the end of the frame where you attach the bumper. What is the solution to this? And also, when I went to tighten the bumper up (not using the reinforcement brackets) I barely tightened the bolts and they stripped out? I love the bumper, but are the other components less than adequate for the job?
Reply
Save
Like
1 - 1 of 2 Posts
C
road armor sucks, I know I have the rear one for the excursion that was made to handle carrying a 38" spare tire but I had to take it off before it broke the bumper. take them to a good fabrication shop and get them beefed up before you powder coat them
Reply
Save
Like
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
The Diesel Stop
A forum community dedicated to all Ford Diesel owners and enthusiasts. Come join the discussion about PowerStrokes, performance, modifications, troubleshooting, towing capacity, maintenance, and more!
Full Forum Listing
Explore Our Forums
99 & up 7.3L Power Stroke Engine & Drivetrain 6.0L Power Stroke Engine and Drivetrain 99 & up Upgrades and Aftermarket - 7.3L Engine Power Strokes 1994-1997 General 7.3L IDI Diesels (Not Powerstrokes) 1988-1993
Top