The Diesel Stop banner
1 - 2 of 2 Posts

· Registered
347 Posts
Discussion Starter · #1 ·
I just installed some Rickson 19.5" wheels on my truck. On the front axle, I have the Dynatrac hub replacements, and the wheel studs appear to be about 1/2" too short compared to the rear wheels. Anyone else run into this type of situation? Anyone have a source for longer 14x2.0mm wheel studs?

Thanks in advance.

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.