if you go to advance auto, they are like $30 a piece...alot cheaper, and they have the zerk fittings on them. are you planning on doing these yourself? i always thought you had to have a special press to put them back in. mine need to be done and i want to do it myself, i just dont know if i have the proper tools for the job.
Time for balljoints have ?????
Dealer says 200.00 for the parts. But I am looking for a premium grade of parts, i.e. greaseable and what I should be doing while replacing them. Runnin OEM size tire and wheel. Longevity is the key here, if the majority recommends OEM then I will stick with it.
Thinking about doing this at home rather than paying the 400.00 they want in labor..
Need advice from people that have done it.
I found this website by searching before I posted but not a lot of information from members.. quad 4x4
Thanks for the help.
Matt
Thinking about doing this at home rather than paying the 400.00 they want in labor..
Need advice from people that have done it.
I found this website by searching before I posted but not a lot of information from members.. quad 4x4
Thanks for the help.
Matt
1 - 2 of 9 Posts
thats good to know. ive been putting mine off too because im still not sure that my joints are bad. it mite also be my bearings.
1 - 2 of 9 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
The Diesel Stop
A forum community dedicated to all Ford Diesel owners and enthusiasts. Come join the discussion about PowerStrokes, performance, modifications, troubleshooting, towing capacity, maintenance, and more!
Full Forum Listing
