[Klutch]

I'm pulling the trans to put in a converter from BTS,pump mods,45 element sprag, extra clutch discs, and some other stuff Brian is going to tell me to do. Is there anything else to do while it is pulled? What should be done short of getting a built trans? I know Brian is going to steer me in the right direction, just looking for some education.

 

[Richter69]

be sure to get a Sonnax spirolock o/d piston return snap ring, a Suncoast 4 dics drum w snap ring is a good idea as well. Replace the center support with a full contact piece from ford, pay special attention to all the clutch pack clearances so they do not allow the presurre plates to make contact with other moving parts and or fall off the splines.