[jasontrammell.2]

Had turbo off and inspected everthing cleaned it up real good put a good coat of antisease on it starts out at 0 and at 200 rpms its around 27 28 pound of pressure any suggestions ....thanks in advance

 

[bismic]

First, tell us what you have - what year and what model. If it is an '04, please tell us where the ICP sensor is located.

Hopefully not too much anti-seize. All you need is a very light coating.

What is the vgt% duty cycle at that point?

I assume this is on a cold engine, but what are your temperatures at that point (EOT, ECT, IAT1, IAT2)?

Also, what is the EBP reading?

 

[jasontrammell.2]

First, tell us what you have - what year and what model. If it is an '04, please tell us where the ICP sensor is located.

Hopefully not too much anti-seize. All you need is a very light coating.

What is the vgt% duty cycle at that point?

I assume this is on a cold engine, but what are your temperatures at that point (EOT, ECT, IAT1, IAT2)?

Also, what is the EBP reading?

I will check it out and post it this afternoon