The Diesel Stop banner

Unit Behind HPOP

1365 Views 8 Replies 5 Participants Last post by  RD97
Hey People, first of all, since this is my first post, I'd like to thank you ALL for the helpful and knowledgeable info you have provided me in the past with multiple issues. I've been a lurker until now. Kinda sounds nasty... Anyway, I have an issue that searching the forum hasn't help solve this time. In fixing a leak with the FRP sender on my 96 250 I realized that whatever is hooked to the back of what I believe is the HPOP is loose. It is located on the driver side of the filter housing down at the bottom in the valley. It appears to slide on a shaft coming out of the back of the HPOP and has a 2 wire connection and looks like it is held in place with a sleeve and a nut. The nut is gone so whatever it is slides back and forth. I recovered a flanged sleeve out of the valley but couldn't find the nut. I just cleaned the valley out with degreaser and hot water to find the fuel leak so it's possible I washed the nut out of the valley. The truck appears to run OK so I'm at a loss to figure out what this thing does. Thanks in advance for any clues.... Auto part Engine Fuel line Automotive engine part Vehicle

Sky Font Landscape Rock
See less See more
1 - 2 of 9 Posts
Geez, that didn't take long to get solved. You do have me worried though as the whole thing slides back and forth with no problem. Thanks EXCAVATOR for the pics but now I kinda need to figure out what o-rings go where. I'll stop @ International tomorrow and get the parts. How does this thing work if it just slides over the shaft and could this be a cause of an additional leak that I've been trying to track??? Also JDBONES, that is not front end of a classic's the back...and it's not a workbench...It's a coffee cup rest while I work on the friggin truck outside because the vette takes up the garage. It's my winter project. 68 SB driver :thumbsup:
1 - 2 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.