The Diesel Stop banner
1 - 1 of 1 Posts

· Registered
16 Posts
Discussion Starter · #1 ·
Hello all, I'm just about to put the heads on the block when I noticed that the piston is sticking up above the deck surface a good .020, gaskets measure .065 out of the box(uncrushed). Thats going to leave about .035-.045 piston to head clearence. Also any advice on getting the motor back into the truck, when I pulled it out I took the heads off first and then the short block with out pulling the tranny or transfer case. Can I install it w/ the heads on or not?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.