The Diesel Stop banner

wiring harness part# verification

1126 Views 11 Replies 4 Participants Last post by  bigblueskies98
my ipr wiring harness is toast... the 2 wires at the plug are one now. i replaced my ipr and upon assembly realised the melted mess...(prob my no start problem) Anyway, the fuel heater connections have been messed with somewhere in the past so i want to replace the whole harness. it has the ipr plug, the fuel heater plugs and one other. anyone have a part# or availability? The whole harness is brittle as well so i would feel better replacing it.

this is the part number i found, correct me if i am wrong.

Fuel filter housing wiring harness F7TZ-9S277-AA

wayne
1 - 4 of 12 Posts
Wayne

Get it from IH. Cost less.
Ford gets it from IH. They do not make it.

Bill
[ QUOTE ]
thank you very much... is the melting of the ipr wiring common???

wayne

[/ QUOTE ]

Most are from fuel leaks. The fuel eats it up over time.
Oil will do same.
The heat speeds it up.

Bill
Just cleanup after your done. Can use some simple green. What ever floats your boat. Spills are not bad. Its the constant soak that shortens the life.

Bill
Wayne

Bet IH couldn't order it because you asked for powerstroke.
You have to ask for your year T444E at IH. Drama between the two.
You cannot mention the word powerstroke at IH.

Bill
1 - 4 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top