working on the truck this weekend....

2382 Views 26 Replies 8 Participants Last post by danjreed, Jun 29, 2007

gilroyracing

Discussion Starter · Jun 20, 2007

I fianally got around to ordering an exhaust from Dale @ Tymar Performance. He is a very nice guy, and knows what hes talking about.

So my plans for the weekend is to install my 3x4" down pipe, my full 4" exhaust, no cat, the muffler, and a 5" polished SS tip.

Gut the EBPV.

I also ordered a boost gauge, and a gauge pod, and i got a pyrometer off of ebay as well. so I will be installing that when it comes in.

I got a Banks Boss Hoss chip from hitechredneck, so i will be installing that this weekend as well.

i will be installing my hitch this weekend too.

I talked to cory about installing the chip, but does anyone have a link, or know where theres a how to site showing step by step how to install the chip?

also have any other links or insite on how to install the gauges post that too.....

thanks in advance....
justin

Save

1 - 1 of 27 Posts

masami

· #3 · Jun 20, 2007

Amen to that. My old banks chip ran 150-200* hotter EGTs than even the old dieselpower chip I had towing. If you can, use stainless steel exhaust band clamps to assemble the exhaust system. They seal up really well and do not put a crimp into the exhaust pipes. Makes disassemly a cinch. Disadvantage is they are about $10 each. Available from NAPA and other fine parts stores as Easy-Seals.

Save

1 - 1 of 27 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month