The Diesel Stop banner

working on the truck this weekend....

2377 Views 26 Replies 8 Participants Last post by  danjreed
I fianally got around to ordering an exhaust from Dale @ Tymar Performance. He is a very nice guy, and knows what hes talking about.

So my plans for the weekend is to install my 3x4" down pipe, my full 4" exhaust, no cat, the muffler, and a 5" polished SS tip.

Gut the EBPV.

I also ordered a boost gauge, and a gauge pod, and i got a pyrometer off of ebay as well. so I will be installing that when it comes in.

I got a Banks Boss Hoss chip from hitechredneck, so i will be installing that this weekend as well.

i will be installing my hitch this weekend too.

I talked to cory about installing the chip, but does anyone have a link, or know where theres a how to site showing step by step how to install the chip?

also have any other links or insite on how to install the gauges post that too.....

thanks in advance....
1 - 14 of 27 Posts
any one have a link showing how to install a chip?
ok thanks......

how do you think that chip will be towing a 30' camping trailer?
^^ ooo its a weld on.... he never said that haha.
thanks for the heads up!
i hope so.
my exhaust was supposed to show up today...... its not here yet...
My pyrometer and gage pod showed up yesterday, and my exhaust showed up today, so im still waiting on my boost gauge to get here, i think it will show up either mon. or tues.

but if everything goes as planned, i will have the exhaust on tomorrow, with the chip and pyrometer installed.
I got the exhaust on... will post a couple pics shortly....

waiting for my boost gauge still. When that shows up i will install the chip and the other gauges.
install went well no problems at all.

the only problems im having is getting the chip to work.....

ill post a pic in a few min
link fixed
I installed the boost and the pyrometer.

the pyro works fine, but the boost gauge up around 10lbs of boost starts to shudder....

what can i do to fix it?
1 - 14 of 27 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.